PARADYNE CORPORATION
ACCULINK 3165 DSU/CSU
|
Card Type |
DSU/CSU |
|
NIC Type |
T1 |
|
Chip Set |
Unidentified |
|
I/O Options |
DTE port, network interface via RJ-45 connector, modem port test jacks (2), power jack, communications port |
|
Maximum Modem Rate |
2400bps |
|
Data Modulation Protocol |
V.22 |
|
Wiring Type |
RJ-48 120ohm shielded twisted pair |
|
Maximum Data Rate |
56Kbps (64Kbps full duplex) |
|
Data Bus |
External |
|
CONNECTIONS | |||
|
Function |
Label |
Function |
Label |
|
Test jack - line in |
CN1 |
Communication port |
CN5 |
|
Test jack - line in |
CN2 |
Modem port via RJ-11 |
CN6 |
|
Power Jack |
CN3 |
Network interface via RJ-45 connector |
CN7 |
|
DTE port (25-pin serial connector) |
CN4 | ||
|
DIAGNOSTIC LED(S) | |||
|
LED |
Color |
Status |
Condition |
|
OK |
Green |
On |
DSU/CSU power is on |
|
OK |
Green |
Blinking |
DSU/CSU is downloading software |
|
OK |
Green |
Off |
DSU/CSU power is off or detecting a system failure |
|
FAIL |
Yellow |
On |
Error has been detected on network |
|
FAIL |
Yellow |
Off |
Error has not been detected on network |
|
FAIL |
Yellow |
Blinking |
DSU/CSU is conducting a self test |
|
TST |
Yellow |
On |
DSU/CSU is executing a test |
|
TST |
Yellow |
Off |
DSU/CSU is not executing a test |
|
SIG |
Green |
On |
DSU/CSU is receiving a recoverable signal from network |
|
SIG |
Green |
Off |
DSU/CSU cannot recover the signal from network |
|
OOF |
Yellow |
On |
Out of frame condition detected on network |
|
OOF |
Yellow |
Off |
Out of frame condition not detected on network |
|
ALM |
Yellow |
On |
Alarm condition detected on network |
|
ALM |
Yellow |
Off |
Alarm condition not detected on network |
|
EER |
Yellow |
On |
Excessive error rate exceeded on network |
|
EER |
Yellow |
Off |
Excessive error rate not exceeded on network |
|
DTR |
Green |
On |
DTR signal is high |
|
DTR |
Green |
Off |
DTR signal is low |
|
TXD |
Yellow |
On |
Receiving all zeros from the DTE |
|
TXD |
Yellow |
Off |
Receiving all ones from the DTE |
|
TXD |
Yellow |
Blinking |
Data is being transferred |
|
RXD |
Yellow |
On |
Transmitting all zeros from the DTE |
|
RXD |
Yellow |
Off |
Transmitting all ones from the DTE |
|
RXD |
Yellow |
Blinking |
Data is being transferred |
|
CTS |
Yellow |
On |
CTS signal is high |
|
CTS |
Yellow |
Off |
CTS signal is low |
|
RTS |
Yellow |
On |
RTS signal is high |
|
RTS |
Yellow |
Off |
RTS signal is low |