Data bus:	32-bit, EISA
Size:	Half-length, full-height card
Hard drive supported:	IDE (AT) interface drives (4)
Floppy drives supported:	360KB, 720KB, 1.2MB, or 1.44MB (2)

CONNECTIONS
Function	Location
IDE drive interface (Primary)	CN1
IDE drive interface (Secondary)	CN2
Floppy drive interface	CN3
Hard Drive activity LED	JP1
Speaker	JP2

USER CONFIGURABLE SETTINGS
Function		Location	Setting
»	IDE Bus 1 (CN1) resistors open	JDR0	open
	IDE Bus 1 (CN1) resistors shorted	JDR0	closed
»	IDE Bus 2 (CN2) resistors open	JDR1	open
	IDE Bus 2 (CN2) resistors shorted	JDR1	closed

MISCELLANEOUS TECHNICAL NOTES

When using this controller, the system will see the drives attached to each connector as a single drive. i.e.: if you have two 100MB drives attached to CN1 the system will see one 200MB drive. However, if have two drives you would like to be recognize individually, you may attach one to CN1 and the other to CN2. Closing Jumpers JDR0 and JDR1, shorting the resistors on the IDE buses, helps to eliminated drive incompatibility caused by different noise filtration methods. This controller supports 256KB, 1MB, or 4MB fast page mode SIMM's, 80nsec or faster. Both sockets of a bank must be filled with the same size SIMM's; and at least one bank must be filled for proper operation.