8 1 2 6 0 A D I A M O N D M A X MAXTOR NO MORE PRODUCED Native| Translation ------+-----+-----+----- Form 3.5"/SLIMLINE Cylinders 6569| 2481| | Capacity form/unform 1280/ MB Heads 2| 16| | Seek time / track 10.0/ 1.0 ms Sector/track | 63| | Controller IDE / ATA3 ENHANCED Precompensation Cache/Buffer 256 KB MAXCACHE Landing Zone Data transfer rate 13.420 MB/S int Bytes/Sector 512 16.700 MB/S ext PIO4 Recording method RLL 8/9 operating | non-operating -------------+-------------- Supply voltage 5/12 V Temperature *C 5 55 | -40 71 Power: sleep 0.6 W Humidity % 5 95 | 5 95 standby 0.8 W Altitude km -0.061 3.048| idle 4.5 W Shock g 20 | 150 seek 5.0 W Rotation RPM 5400 read/write 5.3 W Acoustic dBA 36 spin-up W ECC Bit SMART MTBF h 500000 Warranty Month Lift/Lock/Park YES Certificates ********************************************************************** L A Y O U T ********************************************************************** MAXTOR 85120A/83840A/82560A/81280A DIAMOND JUMPER SETTING J1 IDE Connector J2 Power +----------- --------1-++-----------+ | .................... || * * * * |/---------\ | .......... ......... || * * * * * || O O O O | +----------------------++-----------++---------+ | | | | | | | | | | | | | | | | | | J50 Master/Slave ---+ | | | | | | | +-+12V (Yellow) J48 Cable Select -----+ | | | | | +---+12V Return (Black) J46 4092 Cyl Limitation-+ | | | +----- +5V Return (Black) J44 Factory Reserved -----+ | +------- +5V (Red) J42 Factory Reserved -------+ ********************************************************************** J U M P E R S ********************************************************************** MAXTOR 85120A/83840A/82560A/81280A DIAMOND JUMPER SETTING Jumper Setting ============== +---+---+---+---+---+ |J50|J48|J46|J44|J42| +-------------------------------------+---+---+---+---+---+ | Master/Slave | | | | | | | Only Drive in single drive system* | J | | | | | | Master in a dual drive system* | J | | | | | | Slave in a dual drive system | O | | | | | +-------------------------------------+---+---+---+---+---+ | Cable Select | | | | | | | Disabled* | | O | | | | | Enabled | | J | | | | +-------------------------------------+---+---+---+---+---+ | 4092 Cylinder Option | | | | | | | Disabled* | | | O | | | | Enabled | | | J | | | +-------------------------------------+---+---+---+---+---+ | Factory Reserved | | | | O | | +-------------------------------------+---+---+---+---+---+ | Factory Reserved | | | | | O | +-------------------------------------+---+---+---+---+---+ J=Jumpered O=Open *=Default Systems Using Cable Select -------------------------- Most systems do not use this feature. Unless you are sure that the system that the Maxtor hard drive is being installed in uses Cables Select, do not set up the drive with this feature enabled. Maxtor hard drives support Cable Select - which allows the system to identify Devuce 0 and Device 1 drives on the interface cable. If your system manufacturer for specific procedures for installing hard drives. On Maxtor DiamondMax hard drives, the Cable Select is enabled by installing a jumper on J48. When J48 is installed, remove the jumper from J50.